Installation And Initial Setup; Connecting A Microphone And Speakers Directly; Videoconference System; To Line Output - Yamaha PJP-EC200 User Manual

This section describes connections and setup required for using this unit. The basic setup of this unit is available only
with the DIP switch. For advanced setup, refer to "Using the Web Menu" (page 16).
Notes
• Do not use the mute function on a microphone or PA system connected to this unit to prevent echo generations on the other end.
• Make sure all devices are turned off before connecting a microphone or speakers. Moreover, make sure the microphone and speaker
volumes of all devices are set to the minimum.
• To minimize echo or acoustic feedback, maintain an appropriate distance between the microphone and speakers.
• When connecting external devices, refer to the owner's manual supplied with each device in addition.
• Be sure to use the AC adapter and power cable supplied with this unit.

Connecting a microphone and speakers directly

2
AUTO ETHER
ANALYZER
13
INITIALIZE
PHANTOM
DIP SW
ACTIVE ACTIVE
8
4
3
1
Connect a microphone to MIC LINE
INPUT.
y
• You can use a XLR-type microphone or PHONE-type
microphone.
• You can connect two microphones directly to this unit.
If you use only one microphone, connect it to IN1.
2
Connect speakers with built-in amplifier

to LINE OUTPUT.

Installation and Initial Setup

LINE OUTPUT CONFERENCE MIC/LINE INPUT
R L OUT IN GAIN
MIN MAX MIN MAX
IN2 IN1
12
1
10
STANDBY ON
IN2 IN1
DC IN 12V
5
3
Connect CONFERENCE IN of this unit to
the audio output jack of your PC or

videoconference system.

4
Connect CONFERENCE OUT of this unit
to the audio input jack of your PC or
videoconference system.
5
Connect the AC adapter to DC IN.
6

Connect the power cable to the AC

adapter.
7

Connect the power cable to an AC outlet.

7
6
11