Emerson ASHLAND CF717BS00 Owner's Manual page 6

BP7483 ASHLAND CF717 12/19/13
3. Installing Hanger Ball/Downrod Assemby
3.3
Securely tighten the two setscrews into the motor
coupler until they rest against the downrod.
Pull up on the downrod to make sure the setscrews are
firmly installed against the downrod (Figure 3).
NOTE: The setscrew must be properly installed as
described above, or fan wobble could result.
!
It is critical that the clevis pin in the motor coupler is
properly installed and the setscrews securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
3.4
Make sure the grommet is properly installed in the
motor coupler cover then slide the motor coupler cover
on the downrod until it rests on the motor housing. Be
sure the motor coupler cover is oriented correctly
(Figure 4).
3.5
Pass the 42-inch long motor leads through the opening
in the ceiling cover.
Place the ceiling cover over the downrod. Be sure the
ceiling cover is oriented correctly (Figure 5).
9:59 AM Page 6
(For Standard Mounting) (continued)
WARNING
MOTOR
COUPLER
Figure 3
Figure 4
Figure 5
6
DOWNROD
SETSCREWS (2)
5/32"
SETSCREW
WRENCH
DOWNROD
GROMMET
COUPLER COVER
MOTOR HOUSING
CEILING
COVER
DOWNROD
ETL Model No.: CF717