Removing A Dc-Input Power Supply; Required Tools; Removal Procedure - Cisco Catalyst 4500e Series Installation Manual

Removing and Replacing the Power Supply
Step 13 Check the power supply and system status from the system console by entering show power command.
For more information on this command, refer to the command reference publication for your switch.
Step 14 If the LEDs or show power command output indicate a power problem or other system problem, see
Chapter 5, "Troubleshooting,"

Removing a DC-Input Power Supply

This section describes how to remove a DC-input power supply.

Required Tools

You will need the following tools to perform this procedure:
•
•

Removal Procedure

Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Follow these steps to remove a DC-input power supply:
Turn off the in-line power switch. (Single input only. The triple-input power supply does not have this
Step 1
switch.)
Turn off the main power switch.
Step 2
Verify that power is off to the DC circuit on the power supply you are removing.
Step 3
Loosen the screw on the terminal block cover and remove it from the terminal block (see
Step 4
Figure
Catalyst 4500 E-Series Switches Installation Guide
4-8
A Phillips screwdriver
A 10-mm wrench/socket
4-12). The triple-input power supply has two screws on the cover.
for more information.
Chapter 4 Removing and Replacing FRUs
Figure 4-11
OL-13972-01
or