Ethernet Management Port; Console Port; Supervisor Memory; Switching Modules - Cisco Catalyst 4500e Series Installation Manual

Switching Modules

Ethernet Management Port

The WS-X4013+10GE supervisor engine modules have a 10/100/1000BASE-T Ethernet management
port. Supervisor engines use an RJ-45 connector on the front panel with a link status LED. For the
location of the port, see
TCP/IP-based management services available through inband access also are provided through this port
(Telnet and SNMP). This management port also supports image download.
The 10BASE-T and 10/100BASE-T Ethernet management ports are for network management only.
Note
These ports do not support network switching.

Console Port

The console port is an RJ-45 receptacle. The console port allows you to perform the following functions:
•
•
•
•
EIA/TIA-232 was known as recommended standard RS-232 before its acceptance as a standard by the
Note
Electronic Industries Association (EIA) and Telecommunications Industry Association (TIA).

Supervisor Memory

Table D-2
Table D-2
Supervisor Engine
Supervisor Engine 6-E
Switching Modules
This section describes the Catalyst 4500 E-series Gigabit Ethernet switching modules and includes the
following sections:
•
•
•
•
Catalyst 4500 E-Series Switches Installation Guide
D-4
Figure D-1
Configure the switch from the CLI
Monitor network statistics and errors
Configure SNMP agent parameters
Download software updates to the switch or distribute software images residing in Flash memory to
attached devices
lists the memory and processor specifications for the Supervisor engine.
Supervisor Memory
WS-X4606-X2-E, page D-5
WS-X4648-RJ45V-E, page D-5
WS-X4648-RJ45V+E, page D-6
Switching Module LEDs, page D-7
(WS-X4516-10GE).
512 GB SDRAM Upgradeable to 1GB
128 MB Flash memory
512 KB NVRAM
Appendix D Module Overview and Specifications
OL-13972-01