Cisco Catalyst 4500e Series Installation Manual page 140

Supervisor Engines
On the Catalyst 4503-E and 4506-E switches, you can install the Supervisor Engine in slot 1 only. On
the Catalyst 4507R-E switch, you install the primary supervisor engine in slot 3, and you can install an
optional redundant supervisor engine in slot 4. On the 4510R-E switch, you install the primary
supervisor engine in slot 5, and you can install an optional redundant supervisor engine in slot 6.
The supervisor engines have the following features:
Data path and control for all network interfaces
•
Management functions:
•
–
–
–
• Hot-swapping
Note
To install a supervisor engine, follow the procedure in its installation note.
The supervisor engine introduced with Catalyst 4500-E switches is shown in
Figure D-1
1
1 Status LED
2
Reset button
3
Active Supervisor LED
4 Utilization LEDs
5 Compact flash port
Catalyst 4500 E-Series Switches Installation Guide
D-2
Interface monitoring
Environmental status
SNMP and console/Telnet interface
Packets are not forwarded while the module is removed. A system reboot occurs when a
supervisor engine is reinserted.
Supervisor Engine 6-E, 2x10GE(X2) w/ Twin Gig (WS-X45-Sup6-E)
2
3
4
5
Appendix D
8
9
6
7
6 Uplink ports
7
USB port
8
Console port
9 Management port
Module Overview and Specifications
Figure D-1.
OL-13972-01