Repacking A Switch; Checking The Shipping Container Contents - Cisco Catalyst 4500e Series Installation Manual

Installing the Switch in a Rack
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
Warning
handles on modules (such as power supplies, fans, or cards); these types of handles are not designed
to support the weight of the unit. Statement 1032
This chapter describes how to install Catalyst 4500 E-series switches in a rack. For first-time
installations, perform the procedures in the following sections in the order listed:
•
•
Before starting the installation procedures in this chapter, complete the site-planning checklist in
Note
Table 2-2
For information on installing the supervisor engine and switching modules and verifying switch
Note
operation, refer to the Catalyst 4500 Series Module Installation Guide. For information on configuring
the switching modules, refer to the software configuration guide for your switch and software release.

Checking the Shipping Container Contents

Do not discard the shipping cartons and poly bag when you unpack the switch. Flatten and store them.
Note
You will need the containers if you need to move or ship the switch in the future. Repacking instructions
are provided in
OL-13972-01
Checking the Shipping Container Contents, page 3-1
Rack-Mounting the Switch, page 3-2
of Chapter 2, "Preparing for Installation."
Appendix B, "Repacking a Switch."
C H A P T E R
Catalyst 4500 E-Series Switches Installation Guide
3
3-1