Cisco Catalyst 4500e Series Installation Manual page 33

Chapter 1 Product Overview
• Supervisor Engine IV (WS-X4515)
Supervisor Engine V (WS-X4516)
•
Supervisor Engine V-10GE (WS-X4516-10GE)
•
Supervisor Engine 6-E (WS-X45-Sup6-E)
•
If you move a supervisor engine from a Catalyst 4500 series chassis to a Catalyst 4500-E chassis it must
Note
use Cisco IOS Release 12.2(37)SG or later. Refer to the release note for software upgrade procedures if
needed:
http://www.cisco.com/en/US/products/hw/switches/ps4324/prod_release_note09186a0080758ff3.html
#wp305142
The Catalyst 4500 series and Catalyst 4500 E-series supervisor engines have the following features:
Table 1-5
Feature
Data path and control
Management functions
MAC addresses supported
VLANS
Port aggregation
SNMP
RMON
SPAN
Performance management
Hot-swappable
Gigabit Ethernet (using a
GBIC or SFP)
10-Gigabit Ethernet
(WS-X4516-10GE,
WS-X4013+10GE and
WS-X45-Sup6-E)
Forwarding
OL-13972-01
Supervisor Engine Features
Description
Available on all network interfaces
Interface monitoring
Environmental status
SNMP and console/Telnet interface
32,768 per system (Cisco IOS only)
Up to 4,096 VLANs with IEEE 802.1Q VLAN tagging on all ports and
VLAN Trunking Protocol (VTP)
PAgP
Full implementation, including entity-MIB, all relevant standard MIBs,
and all relevant Cisco MIBs
The first four groups (Ethernet statistics, Alarms, Events, and History)
are on a per-port basis without an optional RMON processing module
2
Supported, which allows you to redirect traffic from any port or VLAN
to a SPAN destination port
Information provided
Supported. On non-redundant systems, packets are not forwarded while
the supervisor engine is removed, and a system reboot occurs when a
supervisor engine is reinserted.
Includes two (four on WS-X4516-10GE and WS-X4013+10GE) Gigabit
Ethernet (1000BASE-X) interfaces for backbone interconnection of
high-performance switches and routers
Includes two 10 Gigabit Ethernet interfaces for backbone
interconnection of high-performance switches and routers
Layer 2, 3, and 4 forwarding (Cisco IOS only)
(Figure 1-8)
(Figure 1-9)
(Figure 1-10)
(Figure 1-11)
1
for 100-Mbps and 1000-Mbps EtherChannel
Catalyst 4500 E-Series Switches Installation Guide
Supervisor Engines
1-17