Cisco Catalyst 4500e Series Installation Manual page 26

Switch Features
Table 1-3
Table 1-3
Feature
Ethernet speeds
Standard equipment
Power supplies
Supervisor engine
support
Catalyst 4500 E-Series Switches Installation Guide
1-10
describes the features of the Catalyst 4507R-E switch.
Features of the Catalyst 4507R-E Switch
Description
• Ethernet (10BASE-T) interface to workstations and repeaters
• Fast Ethernet (100BASE-T) interface to workstations, servers, switches, and
routers
Note Autonegotiation of link speed on each 10/100 port allows migration to
100BASE-T from a 10BASE-T installed base.
• Gigabit Ethernet (1000BASE-T and 1000BASE-X) interfaces for backbone
interconnection of high-performance switches and routers
• 10-Gigabit Ethernet interfaces for backbone interconnection of
high-performance switches and routers
Seven-slot modular chassis with one slot reserved for a supervisor engine,
•
one slot reserved for a redundant supervisor engine, and five slots for
switching modules
Two power supply bays
•
• One hot-swappable fan assembly
• Can support a 1000 W, 1300 W, 1400 W, 2800 W, or 4200W AC-input power
supply or a 1400 W DC-input single or triple-input power supply
• Optional redundant power supply
Supports the WS-X4013+, WS-X4515, WS-X4516, WS-X4516-10GE, and
•
WS-X45-Sup6-E Supervisor Engines
• Holds the ASIC-based forwarding engine (data path) and the management
processor and software (control path)
• Features interface monitoring, environmental status, and SNMP and
console/Telnet interface
Note With a single supervisor, packets are not forwarded while the module is
removed; a system reboot occurs when a supervisor engine is reinserted.
In redundant systems, removing the active supervisor causes the standby
supervisor to become active.
Chapter 1 Product Overview
1
OL-13972-01