Using Arp/Ping Commands - Canon LASER CLASS 700 Series Network Manual

11
Click [OK].
The settings become valid after you reset the print server or restart the machine.
To reset the print server, under [Device Manager], on the left column of the
screen, select [Network] ➞ click [Reset].
The protocol settings are complete.

Using ARP/PING Commands

Instead of using the operation panel of your machine, NetSpot, or the Remote UI,
you can use ARP/PING commands to specify the protocol settings.
1
Start up the MS-DOS prompt or the Command prompt.
If you are using UNIX, display the Console screen, and then log on as a
superuser.
2
Execute the following command to add a static entry to the
arp table.
arp -s <IP Address> <MAC Address>
IP Address: Specify the IP address you want to allocate to the machine.
The IP address consists of four numbers delimited by periods,
ranging from 0 to 255.
Specifying Protocol Settings
2
2-19