Settings Using Arp/Ping Commands; Checking The Current Network Settings - Canon LaserBase MF5770 Network Manual

10
Press [ (-)] or [ (+)] to select <AUTO> or <MANUAL>.
● If you want to specify the ethernet driver settings automatically:
❑
Select <AUTO> ➞ press [OK].
● If you want to specify the ethernet driver settings manually:
❑
Select <MANUAL> ➞ press [OK].
❑
Press [ (-)] or [
❑
Press [ (-)] or [
communication mode ➞ press [OK].
❑
Press [ (-)] or [
❑
(+)] to select <10 BASE-T> or <100 BASE-TX> for specifying the desired ethernet type ➞
Press [ (-)] or [
press [OK].
11
Press [Stop/Reset] to return to the standby display.

■ Checking the Current Network Settings

You can check the network settings of the machine. Settings specified from the operation panel become
effective after the machine is restarted, after the procedure.
1
Press [Menu].
2
(+)] to select <NETWORK SETTINGS> ➞ press [OK].
Press [ (-)] or [
3
(+)] to select <VIEW IP ADDRESS> ➞ press [OK].
Press [ (-)] or [
4
Press [ (-)] or [ (+)] to select <IP ADDRESS>, <SUBNET MASK>, or <DEFAULT GATEWAY> for
displaying the setting you want to check ➞ press [OK].
5
Press [Stop/Reset] to return to the standby display.

Settings Using ARP/PING Commands

1
Start up the MS-DOS prompt or the Command prompt on your computer.
2
Execute the following command to add a static entry to the arp table.
arp -s <IP Address> <MAC Address>
IP Address: Specify the IP address you want to allocate to the machine. The IP address consists of 4
numbers ranging from 0 to 255, using periods (.) as separators. (ie. 172.20.88.125)
MAC Address: Specify the MAC address of the machine. Every second digit is separated by "-". (ie.
00-00-85-05-70-31)
Input Example: arp -s 172.20.88.125 00-00-85-05-70-31
3
Execute the applicable command below to set the IP address for the network board.
ping <IP Address> -l 479
Input Example:
ping 172.20.88.125 -l 479
NOTE
• The character "-l" is the alphabet letter "L."
• The Subnet Mask and Gateway Address are set as <0.0.0.0>.
The preparation for the machine's protocol settings are complete.
(+)] to select <DUPLEX> ➞ press [OK].
(+)] to select <HALF DUPLEX> or <FULL DUPLEX> for specifying the desired
(+)] to select <ETHERNET TYPE> ➞ press [OK].
2
2-3