Canon LASER CLASS 700 Series Network Manual page 36

IMPORTANT
This machine enables you to have the machine directly allocate an IP address, or
you can use DHCP, BOOTP, or RARP to specify the IP address. When the machine
is started or reset, it checks whether DHCP, BOOTP, or RARP is being used, and
then allocates the IP address using the first available protocol.
NOTE
•
It takes about one to two minutes for the machine to check whether DHCP, BOOTP
or RARP can be used. It is recommended that you set unused protocols to 'Off'.
•
Depending on whether you use DHCP, BOOTP, or RARP to allocate the IP
address, you need to start the DHCP server, BOOTP daemon, or RARP daemon.
6
Specify the IP Address, Subnet Mask, and Gateway Address.
In [IP Address], enter the machine's IP address. In [Subnet Mask] and [Gateway
Address], enter the subnet mask and gateway address used by the TCP/IP
network.
NOTE
If you are using DHCP, BOOTP, or RARP, some of the items above are not used.
The values obtained from DHCP, BOOTP, or RARP are listed in the respective text
boxes automatically.
7
Specify the LPD settings.
● For [LPD Print]:
❑
Select [On] or [Off].
● For [LPD Banner]:
❑
Select whether to enable or disable the banner page (the separator page of
each print job).
[Off]:
[Auto]:
[On (Print Last)]: The banner page is always enabled, regardless of the
The banner page is always disabled, regardless of the
banner page output settings.
The banner page is enabled only for print jobs set to output
a banner page, and disabled for print jobs not set to output
a banner page.
banner page output settings. The banner page is output on
the last page.
Specifying Protocol Settings
2
2-17