AMX MVP-7500 Operation/Reference Manual page 27

Long Magnetic
FIG. 22 Separating the support cradle from its movement mechanism
4. Carefully remove the cradle pivot's attachment screw and place it aside for later re-attachment.
5. Carefully slide the black pivot cradle combo unit (battery cover/support cradle) up from the metallic
housing and use the screwdriver to remove the remaining screw from the securing plate (shown in
FIG. 23).
FIG. 23 Sliding out the battery cover/support cradle combo
6. Place this securing plate aside (along with its three securing screws).
Use care when removing this black pivot combo as it is still connected to two
separate internal circuit boards along its backside. The removal of these circuit
boards is the last step before installation of the replacement MVP-WDS/Silver unit.
7. Locate the exposed MVP Interface Connector pin circuit board and use the screwdriver to remove
this board from the combo unit by unscrewing the two screws (A in FIG. 24).
MVP-WDS Wall Docking Station for MVP Panels
Phillips-head
screwdrivers
MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box
Attachment
screw
Gap opening
Support Cradle Pivot
movement mechanism
Remaining MVP Support
Cradle Securing screw
MVP Support Cradle
Securing plate
21