Interface Connector Pins And Functions; Securing An Mvp Panel To An Mvp-Wds - AMX MVP-7500 Operation/Reference Manual

To be detected by the docking station, USB input devices (keyboard / mouse) must be plugged into the
docking station before it is powered-up. The docking station will not detect USB input devices until the
unit cycles power.

Interface Connector Pins and Functions

FIG. 15 gives the pin numbering and function information for the docking stations:
1 - Data - Panel Detect IN
2 - Ground
3 - not used
4 - Ground
5 - not used
6 - Ground
7 - not used
8 - not used
9 - not used
10 - DC Power
11 - Data - Receive
12 - DC Power
13 - Data - Transmit
14 - DC Power
15 - Data - USB Device D-
16 - Data - Cradle Detect
17 - Data - USB Device D+
18 - Data - Panel Detect OUT
FIG. 15 MVP-TDS Connector Pin locations and Pinout function

Securing an MVP Panel to an MVP-WDS

1. Place the MVP-WDS on a flat and level surface.
2. Provide power to the MVP-WDS (refer to the Powering the MVP-WDS section on page 13).
3. Place the MVP on the support cradle so that the alignment pins on the WDS fit into the matching
holes on the bottom of the MVP.
Connector
FIG. 16 Installing an MVP onto an MVP-WDS
4. Once proper alignment is verified, gently angle back the MVP until the rear of the panel makes
contact with the electromagnet. Allow one second to activate the electromagnet.
MVP-WDS Wall Docking Station for MVP Panels
If a USB keyboard has been connected, only on-screen keyboards and keypads will reflect any
external keystrokes sent from the external USB keyboard.
pins
Alignment
guide pins
MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box
2
1
17
18
15