Removing The Mvp-Wds Faceplate - AMX MVP-7500 Operation/Reference Manual

Although there are wiring knockouts are on both sides of the conduit box, the
knockouts on the right side will be used for the MVP-WDS (wall docking station)
connectors, so always secure the conduit box to the stud using the Stud Mounting
Holes on the left side of the box.
2. Using either nails or screws, fasten the conduit box to the stud through the five Stud Fastening
Holes.
3. Remove the wiring knockouts from the right side of the conduit box to accommodate cabling to the
MVP-WDS.
4. Thread the USB and Power cables through the knockouts on the right of the conduit box. It is
recommended that you test these connections before fully installing the WDS.
5. Install the drywall/sheetrock before inserting the MVP-WDS into the conduit box.

Removing the MVP-WDS Faceplate

The faceplate must be removed from the main MVP-WDS unit before any installation procedures can be
done. The unit is shipped without the Die Cut Foam covers (60-5965-47) installed over the two #6-32
Faceplate Security Screws. The foam covers are installed over the faceplate screws only after the
installation is complete and the support cradle is retracted.
1. Place the MVP-WDS face up on a flat level surface.
2. Connect the mini-Phoenix connector from a compatible 12V power supply to the PWR connector
on the side panel (see FIG. 4) to apply power.
Faceplate
Foam covers
MVP Support Cradle
MVP Alignment Guide Pin
MVP Interface Connector pins
Security Release pushbutton/LEDs
FIG. 4
MVP-WDS Docking Station components (front view)
3. Open the Battery Compartment and press the Cradle Activation pushbutton (recessed white button
located near the pins in Battery Slot #2) to angle the Support Cradle forward (FIG. 5).
MVP-WDS Wall Docking Station for MVP Panels
Die Cut
MVP Alignment Guide Pin
MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box
Battery Compartment
Security Latch
Battery Compartment Latch
2-pin mini-Phoenix
power connector
USB connectors (2)
5