AMX MVP-7500 Operation/Reference Manual page 18

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box
Don't disconnect the PWR and USB connectors from the MVP-WDS. The unit must
be installed with these attached.
4. Test the Power and USB connections before fully installing the WDS. Refer to the LED
Indicators table on page 3 for blink pattern information.
Applying power to the MVP-WDS causes the MVP Support Cradle to retract back into
docking station.
5. Disconnect the terminal end of the power cable from the connected power supply.
6. Carefully insert the main unit into the cutout until the Mounting Tabs on the MVP-WDS lie flush
against the wall (FIG. 13).
7. Insert and secure four #4-40 Mounting Screws (not included) into their corresponding holes located
along the sides of the WDS (using a grounded Phillips-head screwdriver) until the WDS is secured
and is flush against the wall.
8. Follow the steps outlined in the Replacing the Faceplate on the MVP-WDS section on page 13 to
angle the MVP Support Cradle forward and re-install the faceplate.
(screws not included)
Die Cut Foam
covers (2)
FIG. 13
MVP-WDS installation configuration for solid surfaces
12
Verify that the terminal end of the power cable is not connected to a power source before
plugging in the 2-pin power connector.
The USB connectors can be from either a USB extension cable, or a wireless USB RF
transmitter.
Flat surface (can
include a wall, podium, or
other level surface)
Install the four #4-40
mounting screws
into the four holes
Faceplate
security
screws (2)
A - Faceplate
(bezel)
Attachment is done
along the edges
of the cutout
Mounting Tab
B - MVP-WDS (Main unit)
MVP-WDS Wall Docking Station for MVP Panels