Installing The New Conversion Kit's Pivot Unit Components - AMX MVP-7500 Operation/Reference Manual

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box
FIG. 24 Removing the attached circuit boards (A & B)
8. Carefully place the first circuit board aside and rotate the black pivot combo unit over to expose the
second circuit board attached to the backside of the unit (B in FIG. 24).
9. Carefully remove this second board by unscrewing the three screws and then gently placing this
board aside (B in FIG. 24).
10. Place the black pivot combo unit aside.

Installing the new conversion kit's pivot unit components

1. Gently align the second circuit board (B in FIG. 24) on the underside of the silver cradle pivot unit
shown in FIG. 24.
DO NOT OVERTIGHTEN these screws or you will crack the board.
2. Use a grounded Phillips-head screwdriver to carefully secure this board to the backside of the unit
using the three securing screws.
3. Rotate the pivot unit back over to expose the installation location for the MVP Interface Connector
pin circuit board (A in FIG. 24) and use a grounded Phillips-head screwdriver to secure this
remaining board to the silver pivot unit by screwing in the two securing screws.
If the connector pins do not properly align after installation, you might have to return
to this step and unscrew these screws by 1/8th of a turn to allow for some very slight
movement.
4. Install the silver Battery Cover to the silver cradle pivot by inserting each battery cover guide into its
corresponding opening along the sides of the pivot as shown in FIG. 25.
22
Circuit board A Circuit board B
MVP-WDS Wall Docking Station for MVP Panels