Installing The Mvp-Wds Into A Flat Surface Using Mounting Screws - AMX MVP-7500 Operation/Reference Manual

Replacement drywall clip sets cab be ordered from AMX.
6. Tighten all four drywall clip sets (screws and clips) until both Mounting Tabs are securely fastened
and flush against the wall.
7. Follow the steps outlined in the Replacing the Faceplate on the MVP-WDS section on page 13 to
angle the MVP Support Cradle forward and re-install the faceplate.

Installing the MVP-WDS Into a Flat Surface Using Mounting Screws

Use #4-40 Mounting screws (not included) to mount the WDS to a flat surface, through the two sets of
holes located on the sides of the WDS.
1. Cut out the surface for the MVP-WDS docking station using the dimensions shown in FIG. 12.
1.19 [30MM] TYP
7.91 [201MM]
FIG. 12 MVP-WDS Wall Mount cutout dimensions using solid surface screws
2. Thread the USB and Power cables through the surface opening, leaving enough slack in the wiring
to accommodate any re-positioning of the unit.
3. Connect the 2-pin power connector and USB cables along the right side of the (un-powered)
MVP-WDS. The faceplate must be removed prior to any surface installation.
MVP-WDS Wall Docking Station for MVP Panels
Refer to SP-5965-01 for detailed installation dimensions (reproduced in FIG. 12).
It is recommended that you cutout the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
The outer frame Mounting Tabs must be installed so thatthey are flush against the mounting
surface.
.52 [13MM] TYP
5.54 [141MM]
MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box
12.70 [323MM] BEZEL OUTLINE
11.06 [281MM]
FRONT BEZEL OUTLINE
R.13 [3.2MM] MAX RADIUS IN 4 CORNERS
THESE 4 HOLES ARE ONLY REQUIRED
WHEN MOUNTING UNIT TO A SOLID
SURFACE (PODIUM, DESK, ETC).
SECURE UNIT WITH #4 SCREWS
CUTOUT
12.10 [307MM]
8.63 [219MM]
BEZEL OUTLINE
11