AMX MVP-7500 Operation/Reference Manual page 12

MVP-WDS Wall Docking Station & CB-MVPWDS Conduit Box
Battery slot 1
Battery slot 2
Cradle
Activation
pushbutton
(located inside
Battery Slot #2)
FIG. 5 Cradle activation pushbutton location and cradle angling
4. Close the battery cover and disconnect the power connector to remove power from the unit and
maintain the support cradle in the forward position.
5. Remove the two #6-32 Faceplate Security Screws from the top rim of the faceplate, using a
grounded Phillips-head screwdriver (FIG. 6).
Security Release pushbutton
Faceplate
FIG. 6 Faceplate screw removal
6. Angle the top rim of the faceplate upwards, and pull it up and over the Security Latch.
7. Grab the bottom rim of the faceplate and push it up (towards the support cradle), then pull it out,
sliding the four faceplate connectors out of the latches along the bottom of the WDS (FIG. 7).
6
Battery Compartment Latch
Security Latch
Battery Compartment Cover
MVP Support
Cradle
Power supply feed
MVP Support Cradle
#6-32 Faceplate
Security Screws
MVP-WDS Wall Docking Station for MVP Panels