Installing The Mvp-Wds Into A Flat Surface Using Mounting Screws - AMX Wall Docking Station MVP-WDS Installation Manual

#6-32 Faceplate
Security Screws (2)
Die Cut Foam
covers (2)
FIG. 12 MVP-WDS installation configuration for drywall surfaces
Replacement drywall clip sets cab be ordered from AMX.
6. Tighten all four drywall clip sets (screws and clips) until both Mounting Tabs are securely fastened
and flush against the wall.
7. Follow the steps outlined in the Replacing the Faceplate on the MVP-WDS section on page 13 to
angle the MVP Support Cradle forward and re-install the faceplate.

Installing the MVP-WDS Into a Flat Surface Using Mounting Screws

Use #4-40 Mounting screws (not included) to mount the WDS to a flat surface, through the two sets of
holes located on the sides of the WDS.
1. Cut out the surface for the MVP-WDS docking station using the dimensions shown in FIG. 13.
MVP-WDS Wall Docking Station for MVP Panels
Install the four
included drywall clip sets
at these locations
A - Faceplate
Refer to SP-5965-01 for detailed installation dimensions (reproduced in FIG. 13).
It is recommended that you cutout the surface slightly smaller than what is outlined in the
installation drawings so that you can make any necessary cutout adjustments.
The outer frame Mounting Tabs must be installed so that they are flush against the mounting
surface.
MVP-WDS Wall Docking Station & CB-MVPWDS Rough-In Box
Four notches are required
to accommodate the four
expansion clips (included)
B - MVP-WDS (Main unit)
Mounting Tab
11