Toshiba e-STUDIO160 Service Handbook page 196

(16) Toner offset
Approx.
94 mm
Step Cause/Defect area
1 Density
2 Paper
3 Fuser
4
5
6
7
e-STUDIO160/200/250 TROUBLESHOOTING
Check items
Density too high?
Recommended paper used?
Fuser unit ground place dam-
aged?
Scratch on heat roller surface?
Heat roller life ended?
Heat roller temperature proper?
If problem persists after measures
are applied, or there is no prob-
lem found in above check, follow
procedure described in right col-
umn.
4 - 74
Measures
Adjust density.
Use recommended paper.
Replace ground plate.
Replace heat roller.
Replace heat roller.
Check heater control circuit.
Replace process unit or heat roller.
December 2002 TOSHIBA TEC