Toshiba e-STUDIO160 Service Handbook page 111

*23. Transfer guide roller
Refer to "3.5 Checking and Replacing the Transfer Guide Roller".
*24. Exit roller
To clean the surface of the exit roller, use a cloth which should be soaked in water and then wrung
strongly.
*25. Pickup roller
To clean the surface of the pickup roller, use a cloth which should be soaked in water and then
wrung strongly.
*26. 2nd pinch roller
To clean the surface of the 2nd pinch roller, use a cloth which should be soaked in water and then
wrung strongly.
*27. Paper guide/2nd paper guide
To clean the surface of the paper guides, use a cloth which should be soaked in water and then
wrung strongly.
*28. 2nd feed roller
To clean the surface of the 2nd feed roller, use a cloth which should be soaked in water and then
wrung strongly.
*29. Separation roller
To clean the surface of the separation roller, use a cloth which should be soaked in water and then
wrung strongly.
*30. Feed roller
To clean the surface of the feed roller, use a cloth which should be soaked in water and then wrung
strongly.
December 2002 TOSHIBA TEC 2 - 9 e-STUDIO160/200/250 PREVENTIVE MAINTENANCE