Replacing The Microprocessor 2 Air Baffle - IBM System x3550 M3 Type 4254 Installation And User Manual

2. Turn off the server and peripheral devices and disconnect the power cords and
3. Align the DIMM air baffle over the DIMMs so that the baffle pin on the left side

Replacing the microprocessor 2 air baffle

To install the microprocessor 2 air baffle (if you removed it), complete the following
steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect the power cords and
3. Align the microprocessor 2 air baffle tab with the hole on the side of the
104
IBM System x3550 M3 Types 4254 and 7944: Installation and User's Guide
all external cables (see "Turning off the server" on page 32).
of the air baffle aligns with the pin hole next to DIMM connector 8 on the system
board, and lower it into the server.
Baffle pin
Baffle pin hole
on page 44.
all external cables (see "Turning off the server" on page 32).
power-supply cage; then insert the tab into the hole on the cage (make sure
that the front end of the air baffle is lined up with the blue touch point tab on the
left side of fan 6). Press the air baffle down until it is securely seated.
DIMM air baffle