Replacing the cover
To replace the server cover, complete the following steps:
1. Align the cover over the server (toward the rear of the server) until the cover
2. Slide the cover forward toward the front of the server until the cover is
Connecting the cables
The following illustration shows the locations of the input and output connectors on
the front of the server.
Baffle tab
Hole for baffle tab
edges slip into position over the chassis.
Important: Before sliding the cover forward, make sure that all the tabs on both
the front, rear, and side of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it will be hard to remove the cover later.
completely closed.
Cover
Microprocessor 2
air baffle
Tab
Chapter 2. Installing optional devices
105