Updating The Server Configuration - IBM System x3550 M3 Type 4254 Installation And User Manual

Figure 3. Front of server
The following illustration shows the locations of the input and output connectors on
the rear of the server.
Figure 4. Rear of server
You must turn off the server before you connect or disconnect cables.
See the documentation that comes with any external devices for additional cabling
instructions. It might be easier for you to route cables before you connect the
devices to the server.

Updating the server configuration

When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup utility
starts automatically so that you can save the new configuration settings.
Some optional devices have device drivers that you must install. For information
about installing device drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see
"Configuring the Gigabit Ethernet controller" on page 121.
106
IBM System x3550 M3 Types 4254 and 7944: Installation and User's Guide