Star Trac 4500 Owner's Manual page 28

Lift the shroud and secure it to the display control panel
support tube, placing the bungee cord around the tube
and hooking it under the rim ofthe shroud as shown. The
bungee cord should lift and hold the shroud halfway up
the front handrail legs.
NOTE: SHROUD NOT SHOWN FOR CLARITY.
U-BOLT
ELEVATION
RECEPTACLE
ELEVATION CAN
MOTOR SHROUD
Lift the front handrail and shroud,
and lower the front handrail legs over
the elevation screws that stick up
from the frame. The legs will pass
through a "DOl bolt on each side, then
rest on the elevation cans. Remove
the cable tie that secure the ribbon
cable to the front handrail leg.
Caution: Take care not to put any
undue strain on the ribbon cable and
connector. Tighten the nuts on the
"DOl bolts, but leave them loose
enough for later adjustment of the
front handrail. Insert the ribbon cable
connector into the receptacle on the
motor control board. It will go in
only one way. Push in firmly until
DISPLAY
the locking arms on the receptacle
CABLE
are engaged.
BUNGEE CORD