Star Trac 4500 Owner's Manual page 25

CORD REPLACEMENT INSTRUCTIONS
I. TURN THE POWER OFF AND UNPLUG THE TREADMILL.
2. US1NG APH1LL1PS SCREW DRIVER, REMOVE THE SCREW ON THE CENTER FRONT OF THE MOTOR SHROUD, SEPARATE THE VELCRO
BY PULL1NG AWAY ON THE SIDES OF THE SHROUD THEN SLIDE THE SHROUD UP THE FRONT RAIL TO ACCESS THE POWER CORD CONNECTION.
3. REMOVE THE GROUND SCREW AND DISCONNECT GROUND WIRE.
4. REMOVE THE BREAKER SCREWS AND DISCONNECT THE LINE
5. USING A
15/16
6. REMOVE POWER CORD.
GROUND TO FRAME
GREEN WIYELLOW STRIPE WIRE
7. INSTALL NEW POWER CORD BY SLIDING THE WIRES THROUGH THE MOUNTING PANEL HOLE.
S, TIGHTEN THE STRAIN RELIEF NUT,
9. CONNECT THE LINE AND NEUTRAL WIRES TO THE BREAKER WITH THE BREAKER SCREWS,
10, CONNECT THE GROUND TO THE FRAME WITH THE GROUND SCREW,
II, SLIDE THE SHROUD DOWN THE FRONT RAIL, PRESS THE SIDES OF THE MOTOR SHROUD ONTO THE SlOES OF THE
SIDE FRAMES, CAUS1NG THE VELCRO TO ATTACH, TIGHTEN THE SCREW IN THE CENTER FRONT OF THE MOTOR SHROUD.
AND NEUTRAL (N) WIRE.
LINE
LOAD
STRAIN RELIEF NUT
STRAIN RELIEF