Brother DPC-8060 Service Manual page 388

A2.1 INSTALLING THE UPDATE DATA TO THE
MACHINE
If you want to update the current program stored in the flash ROM of the main PCB to the newer
version or after you replace the main PCB, install the update program onto the flash ROM.
The program installation requires a PC/AT-compatible computer (which is capable of running
MS-DOS or its compatible OS).
If you use parallel interface
< Connecting the Machine to Your PC >
(1) Make sure that your PC is turned off.
(2) Make sure that the power cord of the machine is unplugged from a wall socket or other power
source.
(3) Connect the parallel interface cable to the parallel port on the back of the machine and secure
it with the lock wires.
(4) Connect the other end of the interface cable to the machine port of your PC and secure it with
the two screws.
< Setting up the Machine and Your PC >
(1) Plug the power cord of the machine into a wall socket, and turn on the power switch while
pressing the [5] key on the machine's control panel.
(2) Check to see that the following pattern displays on the LCD. If it does not display, go back to
step (2) above.
(3) Turn on your PC.
Host computer
Parallel interface cable
Ap p . 2 -1
2
1
Lock wires
2
Confidential