Brother DPC-8060 Service Manual page 325

ERROR MESSAGE
Out of Memory
Paper Jam Duplex
Paper Jam Inside
Paper Jam Rear
Paper Jam Tray1
Paper Jam Tray2
Paper Jam MP Tray
Scanner Locked
Toner Life End
Toner Low
Unable to Init.
(Initialize)
Unable to Print
Unable to Scan
Wrong Paper Size
CAUSE
The machine's memory is full.
The paper is jammed in the duplex
tray.
The paper is jammed inside the
machine.
The paper is jammed in the rear
of the machine.
The paper is jammed in the paper
tray of machine.
The scanner lock is locked.
The toner cartridge and drum unit
assembly is not installed properly,
or the toner cartridge is used up
and printing is not possible.
If the LCD shows "Toner Low",
you can still print, however, the
machine is telling you that the
toner cartridge is near the end of
its life and the toner will soon run
out.
The machine has a mechanical
problem.
Paper is not the correct size.
9-3
ACTION
<Fax sending or copy operation in
progress>
Do one of the following:
- Press [Start] key to send or copy the
scanned pages.
- Press [Stop/Exit] key and wait until
the other operations in progress finish
and then try again.
- Clear the data from the memory.
<Printing operation in process>
Do one of the following:
- Reduce print resolution.
- Clear the faxes from the memory.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Open the document cover, and then
release the scanner lock lever.
Do one of the following:
- Re-install the toner cartridge and
drum unit assembly.
- Replace the toner cartridge with a
new one.
Order a new toner cartridge now.
Turn off the machine's power switch
and then turn it on again. If the error
message continues leave the machine
for several minutes and then try it
again. (The machine can be turned off
for up to 4 days without losing faxes
stored in the memory.
Load the correct size of paper (Letter,
Legal, A4 or Folio) and then set the
"Paper size" ([Menu], [1], [3] keys)
and "Tray Use in Fax Mode" ([Menu],
[1], [7], [2] keys).
Confidential