Brother DPC-8060 Service Manual page 370

(P-3) Unable to print full pages of a document with the "MEMORY FULL" message.
User Check
(1) Press the [Start] key on the control panel to print the data remaining in the machine.
(2) Reduce the complexity of your document or reduce the machine resolution.
NOTE: This problem may appear if the data is too complex.
Possible cause Step
Main PCB 1
failure
(P-4) Headers or footers are not printed out even though they are viewed on PC screen.
User Check
Most laser machines have a restricted area that cannot be printed on. Usually the first two lines
and last two lines of text cannot print (leaving 62 printable lines). Adjust the top and bottom
margins in your document to allow for this.
(P-5) The machine sometimes prints a couple of characters and then ejects the page.
User Check
(For DOS environment only)
The application machine emulation setting and the machine's emulation do not match. Check in
the application software which machine you have selected to make sure the machine is set up
correctly. Remember that the machine emulates widely used machine selections:
HP Laser Jet 6P, HP Laser Jet 6P, Epson FX-850, IBM Proprinter XL
Try setting the machine into HP emulation and then select the HP LaserJet 6P machine in the
application software.
Check
Is it possible to print after
reducing the data of a
document?
9-48
Result Remedy
Yes Replace the main PCB.
Confidential