C. Unpacking And Installing - Canon LBP-2000 Service Manual

C. Unpacking and Installing

When a piece of metal is brought in from a cold to warm place, droplets of water can develop on its
surface. This phenomenon is known as condensation, and the use of an LBP suffering from con-
densation can cause various printing faults.
If the Printer has been brought in from a cold place, leave it alone for at least one hour before
unpacking it.
1. Unpacking the printer
1) Unpack the Printer.
2) Check to make sure that none of the following is missing:
1. power cord
2. toner cartridge
3. dust cover
4. CD-ROM
5. documentation
3) Remove the plastic bag used to cover the Printer, and check to make sure that the covers and
the like are free of image and deformation from transportation.
4) Slide out the cassette, and move the Printer to the site of installation.
5) Place the Printer at the site of installation. (Take care.)
• If the Printer is to be laid on a paper feeder, be sure that the position pins on the paper feeder
fit into the openings in the Printer's bottom.
6) Remove the tape used to keep the parts in place.
7) Open the multifeeder tray, and pull the open/close lever to the front to slide out the front
cover.
8) Remove the protective tape used to keep the transfer charging roller in place.
9) Lock the open/close lever, and close the front cover and the multifeeder tray.
10) Slide in the cassette.
2. Unpacking and installing the cartridge
1) Open the bag used to pack the cartridge, and take out the cartridge.
2) Holding the cartridge as shown in Figure 1-5-13, shake it gently up and down about 5 to 6
times so that the toner inside it will be even.
3) Place the cartridge on a level surface. While holding the top of the cartridge with one hand, pull
the tab carefully with the other hand; then, pull straight out the sealing tape.
4) Open the multifeeder tray, and pull the open/close lever to the front to draw out the front
cover.
5) Holding the cartridge with both hands, fit it in the Printer. At this time, be sure to slide in the
cartridge carefully until it butts against the rear of the Printer.
CHAPTER 1
1 - 11