Canon LBP-2000 Service Manual page 30

CHAPTER 1
4) Open the manual feed tray; while pushing down the holding plate, fit the manual feed cleaning
tool in place as shown.
5) Set the paper guide of the multifeeder manual feed tray to postcard size.
Note: After fitting the manual feed tray cleaning tool in place, check to make sure that it has
been pushed so that the edge of the pickup guide and the step of the manual feed tray
cleaning tool. match. Otherwise, the dirt of the manual feed pickup roller cannot be re-
moved.
5) Press the Go key so that the Printer enters off-line state.
6) Press the Menu key until the status indicator panel indicates 'TEST MENU'.
7) Press the Item key until the status indicator panel indicates 'CLEANING ROLLER'. Then, press
the Enter key so that the Printer starts to clean the roller.
Note: 1. Check to make sure that no paper exists in the multifeeder tray before executing 'CLEAN-
ING ROLLER'. Otherwise, the paper will be picked up, causing a jam.
2. Be sure to detach the cleaning tool after cleaning the manual feed pick up roller.
3. Allow about 10 sec between the start and the end of cleaning.
4. After using it for thee cleaning sessions, or if its surface has become excessively soiled,
replace it with a new cleaning sponge.
7) Open the paper guide, and detach the cleaning tool while pushing down the Holding plate.
8) Press the Go key so the Printer enters on-line state.
1 - 24
Figure 1-7-5
Figure 1-7-6