Installation; A. Points To Note About Installation; B. Selecting The Site - Canon LBP-2000 Service Manual

V. INSTALLATION

A. Points to Note About Installation

The Printer is thoroughly adjusted and inspected at the factory before it is packed and shipped.
Installation work is important in that the Printer must perform in the field as it did when it passed
the factory inspection.
The service engineer must have a full understanding of the machine, and install it in an appro-
priate site using specific steps, following up the work with a thorough inspection.

B. Selecting the Site

The site of installation must meet the following requirements; if possible, visit the site of installa-
tion before the Printer is delivered.
1. Power supply
The power supply must satisfy the following:
• AC: ±10% of ratings
• Frequency: 50/60 ±2 Hz
2. Operating environment
The site must satisfy the following:
• Its floor must be level.
• Its temperature and humidity are as follows:
Ambient temperature: 7.5ºC to 32.5ºC (45.5 to 90.5ºF)
Ambient humidity:
• It must be well ventilated, without accumulation of heat.
Avoid the following areas:
• subject to direct rays of the sun; as necessary, provide thick curtains to block out the sun.
• subject to magnetism (magnet, magnetic filed).
• subject to vibration.
• subject to dust.
• near a source of fire or water.
5% to 90% RH (There must not be condensation.)
CHAPTER 1
1 - 9