Kohler COMMAND CV17-745 Service Manual page 43

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
26
18
24
17
23
21
15
22
20
19
14
or
Figure 5-7. Typical Carburetor - Exploded View.
Inspection/Repair
To clean vent ports, seats etc., use a good
commercially available carburetor solvent, such as
Gumout™, and clean, dry compressed air to blow out
internal channels and ports. Use a suitable shop rag to
prevent debris from hitting someone.
Carefully inspect all components and replace those
that are worn or damaged.
• Inspect the carburetor body for cracks, holes and
other wear or damage.
4
2
3
1
25
16
9
11
13
12
www.mymowerparts.com
Fuel System and Governor
6
1. Carburetor Body
2. Idle Fuel Adjusting Screw*
3. Idle Fuel Adjusting Spring*
4. Passage Cover
5. Cover Gasket*
6. Cover Retaining Screw
5
7. Main Jet
8. Ground Lead (Solenoid only)
9. Fuel Bowl Gasket
10. Float Kit
11. Fuel Bowl
7
12. Bowl Retaining Screw Gasket
13. Bowl Retaining Screw
14. Shut-off Solenoid Assembly
15. Throttle Shaft/Lever
8
16. Throttle Plate
17. Choke Shaft
18. Choke Plate
19. Air Filter
20. Collar
21. Spring
10
22. Ring
23. Choke Lever
24. Idle Speed Screw
25. Idle Speed Spring
26. Setscrews (Plates - 4)
*Included in Carburetor Repair Kit.
• Inspect the float for cracks, holes, and missing or
damaged float tabs. Check the float hinge and
shaft for wear or damage.
• Inspect the fuel inlet needle and seat for wear or
damage.
• Inspect the tip of the low idle fuel adjusting needle
(if equipped), for wear or grooves.
• The choke plate is spring loaded. Check to make
sure it moves freely.
Section 5
5.9