Kohler COMMAND CV17-745 Service Manual page 177

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Figure 11-20. Torquing Stator Screws.
4. Route the stator leads in the crankcase channel,
then install the backing plates and stator wire
bracket (if used). Secure with the four hex. flange
screws. See Figures 11-21 and 11-22. Torque the
screws to 7.3 N·m (65 in. lb.).
Figure 11-21. Route Stator Leads in Groove.
Figure 11-22. Installing Backing Plates and Stator
Wire Bracket.
Install Flywheel
Flywheel Can Cause Personal Injury!
Using improper procedures to install the flywheel can
crack or damage the crankshaft and/or flywheel. This
not only causes extensive engine damage, but can also
cause personal injury, since broken fragments could be
thrown from the engine. Always observe and use the
following precautions and procedures when installing
the flywheel.
NOTE: Before installing the flywheel, make sure the
Figure 11-23. Clean and Dry Taper of Crankshaft.
Figure 11-24. Carefully Align Keyway to Key.
1. Install the woodruff key into the keyway of the
www.mymowerparts.com
WARNING: Damaging Crankshaft and
crankshaft taper and flywheel hub are clean,
dry, and completely free of any lubricants. The
presence of lubricants can cause the flywheel
to be over stressed and damaged when the
hex. flange screw is torqued to specifications.
crankshaft. Make sure that the key is properly
seated and parallel with the shaft taper.
Section 11
Reassembly
11
11.7