Kohler COMMAND CV17-745 Service Manual page 155

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Remove Connecting Rods with Pistons
and Rings
1. Remove the two hex. flange screws securing the
closest connecting rod end cap. Remove the end
cap. See Figure 9-54.
Figure 9-54. Removing Connecting Rod End Cap.
NOTE: If a carbon ridge is present at the top of
either cylinder bore, use a ridge reamer
tool to remove it before attempting to
remove the piston.
2. Carefully remove the connecting rod and piston
assembly from the cylinder bore. See Figure 9-55.
NOTE: The cylinders are numbered on the
crankcase. Use the numbers to mark
each end cap, connecting rod and piston
for reassembly. Do not mix end caps
and connecting rods.
Figure 9-55. Removing Connecting Rod and Piston
Assembly.
3. Repeat the above procedure for the other
Remove Crankshaft
1. Carefully pull the crankshaft from the crankcase.
Figure 9-56. Removing Crankshaft.
Remove Flywheel End Oil Seal
1. Remove the oil seal from the crankcase. See
Figure 9-57. Removing Oil Seal.
www.mymowerparts.com
connecting rod and piston assembly.
See Figure 9-56.
Figure 9-57.
Section 9
Disassembly
9
9.15