Kohler COMMAND CV17-745 Service Manual page 197

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Drain Plug
Figure 11-84. Install Oil Drain Plug(s).
NOTE: Make sure that both oil drain plugs are
installed and torqued to the above
specifications to prevent oil leakage.
5. Add oil to bring the level up to the ''Full'' mark and
reinstall the dipstick.
Connect Spark Plug Leads
1. Connect the leads to the spark plugs. See Figure
11-85.
Figure 11-85. Connect Spark Plug Leads.
Prepare the Engine for Operation
The engine is now completely reassembled. Before
starting or operating the engine, be sure to do the
following.
1. Make sure all hardware is tightened securely.
2. Make sure the oil drain plugs, oil sentry pressure
3. Fill the crankcase with the correct amount, weight,
4. Adjust the carburetor, idle fuel needle, or idle
Testing the Engine
It is recommended that the engine be operated on a
test stand or bench prior to installation in the piece of
equipment.
1. Set the engine up on a test stand. Install an oil
2. Adjust the idle speed screw and high-speed stop
www.mymowerparts.com
switch, and a new oil filter are installed.
and type of oil. Refer to oil recommendations and
procedures in the ''Safety and General
Information'' and ''Lubrication System'' sections.
speed adjusting screw as necessary. Refer to
Section 5, ''Fuel System and Governor''.
pressure gauge. Start the engine and check to be
certain that oil pressure (20 psi or more) is
present. Run the engine at idle for 2-3 minutes,
then 5-6 minutes more between idle and
midrange. Adjust the carburetor mixture settings
as necessary (as available).
as necessary. Make sure the maximum engine
speed does not exceed 3750 RPM (no load).
Section 11
Reassembly
11
11.27