Kohler COMMAND CV17-745 Service Manual page 194

Kohler Engine Parts Call K&T 606-678-9623 or 606-561-4983
Section 11
Reassembly
8 mm Governor Lever and Hole Position/RPM Charts cont.
CV26, CV745 EFI Engines
Governor Shaft Maximum RPM
Configuration
High Idle
3888
3780
3672
Standard 3564
(Parent Material) 3456
3348
3240
3132
3024
Install Electric Starter Motor
1. Install the starter motor using the two hex. flange
screws. Position the lift bracket as shown to also
secure the dipstick tube. See Figure 11-75. Some
inertia-drive starters have a pinion cover and
spacers on the starter bolts.
2. Torque the two hex. flange screws to 15.3 N·m
(135 in. lb.).
3. On models with a solenoid shift starter, connect
the leads to the solenoid.
Lift Bracket/Dipstick
Tube Support
Starter
Figure 11-75. Installing Starter and Lift Bracket.
4. Install the dipstick tube and align the mounting
hole with the threaded hole in the lift bracket.
Secure with the M5 hex. flange screw. Torque the
screw to 4.0 N·m (35 in. lb.). See Figure 11-76.
11.24
Intended
Standard Throttle Control
Spring Color
WOT
3600 Orange
3500 Black
3400 Red
3300 Green
3200 Red
3100 Green
3000 Blue
2900 Clear
2800 Clear
www.mymowerparts.com
With WAWB (Wide Area Walk
Behind) Throttle Control
Spring Color
Hole No.
3
3
3
2
2
1
1
1
1
Figure 11-76. Installing Dipstick Tube.
Install Fuel Pump
WARNING: Explosive Fuel!
Gasoline may be present in the carburetor and fuel
system. Gasoline is extremely flammable and its
vapors can explode if ignited. Keep sparks and other
sources of ignition away from the engine.
1. Install the fuel pump and lines as an assembly.
Connect the pulse line to the crankcase vacuum
fitting. See Figures 11-77 and 11-78.
NOTE: Fuel pumps may be made of metal or
plastic. If a new fuel pump is being
installed, make sure the orientation of the
new pump is consistent with the
removed pump. Internal damage may
occur if installed incorrectly.
Hole No.
Red 3
Purple 3
Blue 3
Orange 2
Green
2
Red 1
Purple 1
Blue 1
Clear 1