Setting The Ramp Rate - INSTEON LampLinc 2457D2 (Dual-Band) Owner's Manual

Setting the Ramp Rate

NOTE: Setting the Ramp Rate does not change/affect the On-Level brightness.
1) Setting the Ramp Rate is done using the brightness level as an indicator for how fast LampLinc
should ramp. Use the Up and Down buttons on LampLinc to set the brightness to a brighter level for a
faster Ramp Rate or dimmer for a slower Ramp Rate. 100% corresponds to a 0.1-second Ramp Rate
and full-off corresponds to a 9-second Ramp Rate.
The following table gives the approximate relationship between the brightness you set in this step and
the Ramp Rate you get.
Approximate
Brightness Level
90-100%
77-87%
65-74%
52-61%
39-48%
26.35%
13-23%
1-10%
Less than 1%
2) Once you reach the desired brightness (Ramp Rate), double-tap the Set button on LampLinc
LampLinc beep and the load
will
3) Test the Ramp Rate settings by tapping the Up and Down buttons on LampLinc
LampLinc respond appropriately
will
The local Ramp Rate has now been set. If you would like to set up a Controller to set LampLinc to the
programmed Ramp Rate, proceed to Linking an INSTEON Controller to LampLinc.
If the load flashes twice or you heard two beeps, you didn't double-press the Set button fast enough
and the On-Level was actually set up twice. Reset the correct On-Level and try setting the Ramp Rate
again from step 1.
LampLinc Owner's Manual
Ramp Rate
in seconds
0.1
0.2
If the load is ramping to less than full
0.3
brightness, then the time it will take
will be proportionately less. For
0.5
instance, if the load is going to half-
2.0
brightness, the time it will take for a
given Ramp Rate will be halved.
4.5
6.5
8.5
9.0
flash once
will
NOTE:
Page 7 of 19
NOTE: