Installing Lamplinc; Using Lamplinc; Using The Buttons; Status Led And Beeper Activity - INSTEON LampLinc 2457D2 (Dual-Band) Owner's Manual

Installing LampLinc

1) Plug the lamp/device (the load) you want to control into the outlet on LampLinc
2) Plug LampLinc into an unswitched wall outlet
The load may turn on
If the LampLinc Status LED is solid green, installation is complete
If the Status LED is solid red, tap the Up button
The LampLinc Status LED will turn on solid green and the load will turn on
3) If the load does not turn on, turn it on manually using the switch on the load itself
NOTE: After completing installation, you will not be able to use the load's built-in switch to control the load unless
Load Sensing is enabled. See Enabling/Disabling Load Sensing.

USING LAMPLINC

Using the Buttons

The LampLinc buttons will control the load and any Linked Responders. LampLinc or the Responders will behave
differently depending on whether you tap, double-tap, or hold down the buttons.
Button
Up
Down

Status LED and Beeper Activity

Status LED Activity
Status LED Activity
Solid green
Solid red
Blinking green
Blinking red
Double-blinking green
Double-blinking red
Tapping the Set Button
If LampLinc is in a setup mode, tap the Set button to exit the setup mode and return to normal operation.
Beeper Activity
Beeper Activity
Single beep
Double beep
Long beep
Continuous beep (once per second)
LampLinc Owner's Manual
Tap
Ramp to On-Level
Ramp to Off
Load is on
Phase Bridging Detection Mode has been initiated
Load is off
Linking Mode
Phases have been bridged (if used as a secondary device
during Phase Bridging Detection Mode)
Unlinking Mode
Multi-Linking Mode
Multi-Unlinking Mode
Entered setup mode or moved to the subsequent setup mode
Exited setup mode (if Set button was tapped)
Feature was programmed (e.g., On-Level, Ramp Rate)
Link established – LampLinc will exit setup mode
Timed out of setup mode
Initiated Phase Bridging Detection Mode
Page 5 of 19
Double-tap
Full-bright instantly
Full-off instantly
LampLinc Status/Setup Mode
LampLinc Status
Press & hold
Brighten until released
Dim until released