Table Of Contents; Manual; Joint; Front Differential - Arctic Cat XC 450i 2012 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
3. While holding the actuator firmly forward, tighten
the front cap screw to hold the actuator in place; then
install but do not tighten the two remaining cap
screws.
4. Loosen the front cap screw; then tighten the cap
screw on the driveshaft side.
 NOTE: It is important to tighten this cap screw while
the others are loose to ensure proper seating of the
actuator.
5. Tighten the remaining cap screws; then connect the
electrical plug to the main harness.
6. Turn the ignition switch to the ON position and
check the operation by shifting the selector switch
several times.
7. Secure the wiring harness to the frame with a nylon
cable tie.
92
www.mymowerparts.com

Front Differential

REMOVING DIFFERENTIAL
1. Secure the ATV on a support stand to elevate the
wheels.
Make sure the ATV is solidly supported on the support
stand to avoid injury.
AG925 2. Remove the drain plug and drain the gear lubricant
into a drain pan; then reinstall the plug and tighten to
45 in.-lb.
3. Remove the front wheels.
KC295A
4. Pump up the hand brake; then engage the brake lever
lock.
5. Remove the cotter pin securing the hub nut; then
remove the nut.
6. Release the brake lever lock.
7. Remove the upper and lower ball joint cap screws
taking care not to strip the threads.
Apply pressure to hold the ball joint firmly in the knuckle
or the threads will be stripped when the retaining cap
screws are removed.
AG926

Manual

Table of Contents

! WARNING
CAUTION
ATV0082A
AF628D