Table Of Contents; Manual; Throttle Control - Arctic Cat XC 450i 2012 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
3. Install the new gauge and secure with the mounting
nuts; then plug the harness into the gauge and secure
the gauge pod with the machine screws. Tighten
securely.
Handlebar Grip
REMOVING
1. Loosen but do not remove the cap screw in the end of
the handlebar; then tap lightly on the head to dis-
lodge the handlebar plug.
2. Grasp the end and remove the cap screw, plug, and
end cap.
3. Using a sharp utility knife, split the handlebar grip
from end to end and peel off the rubber.
4. Using an adhesive solvent, clean all glue residue
from the handlebar.
116
www.mymowerparts.com
INSTALLING
1. Apply a liberal amount of Handlebar Grip Adhesive
to the inside of the new grip.
2. Slide the grip onto the handlebar until it is fully
seated with the smooth part of the grip facing up.
 NOTE: A quick, firm push is required to seat the
grip completely on the handlebar. Install while the
glue is wet.
3. Wipe off any excess glue; then secure the grip with
the plug, end cap, and cap screw.
Throttle Control
REMOVING
1. Remove the two machine screws securing the throt-
tle control to the handlebar.
2. Slide the grommet out of the lower half of the throt-
tle control; then remove the cable from the actuator
arm.
KC310
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control lever.
KC309A
4. Remove the actuator arm and account for a bushing.
Note the position of the return spring for installing
purposes.
KC308

Manual

Table of Contents

AF676D
AF677D