Table Of Contents; Manual; Joint - Arctic Cat XC 450i 2012 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
CLEANING AND INSPECTING
 NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Clean all knuckle components.
2. Inspect the bearing for pits, gouges, rusting, or pre-
mature wear.
3. Inspect the knuckle for cracks, breaks, or porosity.
4. Inspect threads for stripping or damage.
ASSEMBLING AND INSTALLING
1. Install the bearing; then install the snap ring making
sure it seats into the knuckle.
2. Install the knuckle to the upper and lower ball joints
and secure with the two cap screws. Tighten to 35 ft-
lb.
3. Install the tie rod end and secure with the nut.
Tighten to 30 ft-lb; then install a new cotter pin and
spread the pin.
 NOTE: During assembling, new cotter pins should
be installed.
4. Apply a small amount of grease to the hub splines.
5. Install the hub assembly onto the splines of the shaft.
6. Secure the hub assembly with the nut. Tighten only
until snug.
118
www.mymowerparts.com
7. Secure the brake caliper to the knuckle with two new
"patch-lock" cap screws. Tighten to 20 ft-lb.
PR287A
8. Pump the hand brake lever; then engage the brake
lever lock.
9. Secure the hub nut (from step 6) to the shaft. Tighten
to 200 ft-lb.
10. Install a new cotter pin and spread the pin to secure
the nut.
11. Install the wheel; then using a crisscross pattern,
tighten to 80 ft-lb.
12. Remove the ATV from the support stand.
Measuring/Adjusting Toe-
KC313A
1. Thoroughly wash the ATV to remove excess weight
(mud, etc.).
2. Refer to the specifications and ensure the tires are
properly inflated to the recommended pressure.
 NOTE: Ensure the inflation pressure is correct in
the tires or inaccurate measurements can occur.
3. Place the ATV in a level position taking care not to
push down or lift up on the front end; then turn the
handlebar to the straight ahead position.
 NOTE: When measuring and adjusting, there should
be a normal operating load on the ATV (without an
operator but with Arctic Cat approved accessories).

Manual

Table of Contents

Out
KC305
KC283