Running Lights - Arctic Cat XC 450i 2012 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983

RUNNING LIGHTS

The running lights are located outboard of the headlights.
To replace the running light bulbs, use the following pro-
cedure.
1. Rotate the bulb socket counterclockwise to release
from light housing; then press in on the bulb and turn
counterclockwise to release from the socket.
2. Install a new bulb and press in rotating clockwise to
secure; then place the socket into the light housing
and turn clockwise to secure.
BACK-UP LIGHTS
The back-up lights are located outboard of the taillights-
brakelights. To replace the back-up light bulbs, use the
following procedure.
1. Remove the taillight housing cover (see Taillights-
Brakelights in this section).
2. Remove two screws securing the back-up light
socket to the taillight housing. Account for a small
gasket.
www.mymowerparts.com
3. Twist the bulb counterclockwise and remove from
the socket; then press in and rotate the new bulb
clockwise.
4. Secure the socket to the housing making sure the
gasket is in place.
5. Install the housing cover.
CHECKING/ADJUSTING HEADLIGHT
KC428A
AIM
The headlights can be adjusted vertically and horizon-
tally. The geometric center of the HIGH beam light zone
is to be used for vertical and horizontal aiming.
1. Position the ATV on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).
KC428B
NOTE: There should be an average operating
load on the ATV when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-point
of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the verti-
cal mark 5 cm (2 in.) below the horizontal mark on
the aiming surface.
KC435A
Manual
Table of Contents
KC436A
ATV-0070C
15