Table Of Contents; Manual; Joint - Arctic Cat XC 450i 2012 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. Measure the distance from the outside edge of each
handlebar grip to equal reference points on each side.
5. Adjust the handlebar direction until the two measure-
ments are equal; then secure the handlebar.
 NOTE: Care must be taken not to allow the handle-
bar to turn while securing it.
 NOTE: The front wheels do not have to be removed
to adjust the tie rod. Also, care should be taken not to
disturb the handlebar position.
6. Using a permanent marker of some type, mark the
center of each front tire (at a height parallel to the
belly panel).
7. Measure the distance between the marks (at a height
parallel to the belly panel) at the front side; then
record the measurement.
8. Push the ATV forward until the marks are parallel to
the belly panel on the back side; then measure the
distance between the marks.
9. The difference in the measurements must show 1/8-
1/4 in. toe-out (the front measurement 1/8-1/4 in.
more than the rear measurement).
10. If the difference in the measurements is not within
specifications, adjust both tie rods equally until
within specifications.
 NOTE: Prior to locking the jam nuts, make sure the
ball joints are at the center of their normal range of
motion and at the correct angle.
www.mymowerparts.com
Front Bumper Assembly
REMOVING
Remove the four front cap screws securing the bumper
support tubes to the frame.
INSTALLING
Install the cap screws in the support tubes to frame.
Tighten the cap screws securely.
Front Body Panel/Fender
REMOVING
1. Remove the seat; then remove four reinstallable riv-
ets and the side panels.
AF789D
2. Remove two cap screws and two reinstallable rivets;
then remove the gas tank cap and remove the gas
tank cover. Reinstall the gas tank cap.
3. Remove the shift lever knob.
4. Remove two reinstallable rivets, two fender bolts,
and four cap screws; then lift the front fender panel
off and set aside. Account for the shift lever spring.
733-559A

Manual

Table of Contents

KC450A
KC453A
119