Brother DCP-9270CDN Basic User's Manual page 115

Error Message
No Permission
No Toner
No Tray
No Waste Toner
Out of Memory
Print Unable XX
Registration
failed.
86
Cause
You have attempted to print in
colour using a Secure Function
Lock ID that is restricted to mono
printing only. The print job will be
cancelled.
The toner cartridge for the colour
indicated on the LCD is not
installed correctly.
The paper tray indicated on the
LCD is not installed properly.
The waste toner box is not
installed properly.
The machine's memory is full.
The machine has a mechanical
problem.
Registration failed.
Action
Contact your administrator to check your
Secure Function Lock Settings.
Pull out the drum unit. Take out the toner
cartridge for the colour indicated on the
LCD, and then put it back into the drum unit.
Re-install the paper tray that is indicated on
the LCD.
Re-install the waste toner box. (See
Replacing the waste toner box on page 56.)
Copy operation in progress
Do one of the following:
 Press Mono Start or Colour Start to
copy the scanned pages.
 Press Stop/Exit and wait until the other
operations in progress finish, and then
try again.
 Add optional memory. (See Memory
board in Appendix B of the Advanced
User's Guide.)
Print operation in process
Do the following:
 Reduce the print quality. (See Basic tab
in the Software User's Guide.)
Do one of the following:
 Turn off the machine, wait for a few
minutes, and then turn it on again.
 If the problem continues, call your
Brother dealer.
Do one of the following:
 Turn off the machine's power switch.
Wait a few seconds, then turn it on
again.
 Try Manual Registration, MENU,
Printer, Manual Regist.. (See
Manual Registration on page 82.)
 Put in a new belt unit. (See Replacing
the belt unit on page 50.)
 If the problem continues, call your
Brother dealer.