Sewing Preparation; Foot Control; Slide-On Table - Bernina 560 Instruction Manual

Sewing preparation

Sewing preparation
power Switch/power cable
6
5
4
3

foot control

2
3

Slide-on table

18
1 Power Switch
The sewing computer is switched on («I») and off («0») with the power switch.
1
I the sewing computer is switched on
2
0 the sewing computer is switched off
2 Power plug socket
3 Foot control socket
4 Connection for embroidery module
5 PC-connection for embroidery software
6 USB-connection
connecting the foot control
⦁
unwind the cable
⦁ plug the cable in the outlet 1
1
⦁
unwind the cable to the desired length and slip into 4 or 5
Sewing speed control
Control the sewing speed by pressing the foot control 2 more or less.
4
adjust needle down or up
⦁ sink the heel back 3 on the foot control
6 5
►
the needle adjusts the position up/down
removing the foot control
⦁
wind the cable around the reel
⦁ plug cable into 6
⦁ turn the handwheel (see page 13)
1
►
needle is raised
⦁ raise presser foot lever 1 up
►
presser foot is lifted
The slide-on table increases sewing surface.
2
attaching the slide-on table
⦁ raise the needle and presser foot
⦁
slide over free-arm to the right until it engages
removing the slide-on table
⦁
raise the needle and presser foot
⦁ press button 2 down
⦁
pull slide-on table to the left
034790.50.04 _2013-03_Manual_B560_EN
uSa/canada only: use only foot controller type LV-1 with
sewing computer B 560.