Bernina 560 Instruction Manual page 161

Troubleshooting
Fault Cause
Display is inactive
̶ Calibration data incorrect
̶ ECO-function active
Stitch width not
̶ Setting activated in the security
adjustable
Sewing-/ ̶ Sewing computer fails to run or runs slowly
Embroidery
computer ̶ Turn power switch to «0» (off)
Upper thread
̶ Not activated in the Setup Program
indicator does not
respond
Lower thread ̶ Not activated in the Setup Program
indicator does not
respond
Lower thread
̶ Thread used/broken
indicator reacts ̶ Bobbin inserted incorrectly
̶ Brake spring is missing
Update error
̶ USB stick is not recognized
̶ Update process is blocked (hourglass
̶ Update-data aren't identified
LED sewing light ̶ LED defective
do not light up
̶ deactivated in the Setup-Program
General
Explanation
Sewing-/
̶ Deleting or overwriting data, e.g.
Embroidery
computer
̶ Stitch number not known in direct entry
̶ Stitch selection not possible in the
̶ Raise the presser foot
160
program
stays on display)
Repair
drawers
combination mode
034790.50.04 _2013-03_Manual_B560_EN
Repair
⦁
re-calibrate the Display in the Setup Program
⦁ turn off ECO function
⦁
deactivate setting
⦁ alter the speed control
⦁
place the sewing computer in a warm room one hour before use
⦁ turn the power switch to «I» (on)
⦁ take the sewing computer to the nearest authorized
BERNINA dealer
⦁
activate in the Setup Program
⦁ activate in the Setup Program
⦁
wind thread and thread
⦁ insert bobbin correctly
⦁
insert brake spring into bobbin case
⦁
use a BERNINA USB stick
⦁ remove the stick and turn the sewing computer off and on
again. Proceed with the update as indicated by the message
⦁
don't save update-data in a folder
⦁ unzip update-data
⦁ take the sewing-/embroidery computer to the nearest
authorized BERNINA dealer
⦁
activate in the Setup Program
Messages
⦁
confirm with or cancel with
⦁
check command entered and enter a new number
⦁
make another selection
⦁ the presser foot is raised