adjusting embroidery settings
1
2
automatic thread cutter and securing stitches
̶ the number and type of the securing stitches before the thread is cut can
be programmed
̶ standard = no securing stitches programmed
⦁
touch function 5 for securing stitches in place or function 6 for forward
securing stitches
5
6
⦁
using the arrow icons two to six securing stitches can be programmed
⦁
touch «Embroidery settings»-icon
The settings for embroidery speed and the upper thread tension can be
adjusted in the same way like the settings for sewing. (see page 46)
⦁
touch icon 1
►
when changing the thread color the automatic cut of the thread is activated
or deactivated
⦁
touch icon 2
⦁
to turn automatic thread cutter on or off
⦁
touch icon 3
⦁
to calibrate the hoop
3
calibrating the hoop
The hoop calibration adjusts the needle to the center of the hoop. Adjustments
can only be done if the embroidery module and the oval hoop are attached.
This procedure has to be done only once as it is the same for all hoop sizes.
⦁
place embroidery template into the embroidery hoop
⦁
start the adjustment by pressing
►
the hoop is checked and the needle positioned to the center
⦁
if the needle is not positioned exactly in the center of the embroidery
template, it has to be centered by using the arrow icons
⦁
confirm with
►
the adjustment is saved
034790.50.04 _2013-03_Manual_B560_EN
Place the fabric in the embroidery hoop. The embroidery template is
located well in the hoop.
Setup Program
47