Legs Assembly And Parts - Beta EVO 4T Owner's Manual

4

LEGS ASSEMBLY AND PARTS

Apply the legs to the vehicle and tighten
the screws 1 to the torque indicated.
ATTENTION: Tightening of the screws
should be carried out by adjusting the
torque wrench to to the stability torque with
1 10Nm
repeated tightening until stability torque has
been achieved.
Grease the wheel bolt.
Apply wheel and wheel bolt.
Apply brake caliper, disc cover and fender.
Tighten to the torque indicated.
10Nm
Place the vehicle on the ground.
Compress and release the fork 3-4 times.
Tighten the wheel bolt and the screws of
the foot.
25Nm
ATTENTION: Tightening of the screws
should be carried out by adjusting the
torque wrench to to the stability torque with
repeated tightening until stability torque has
been achieved.
Tighten to the torque indicated.
10Nm
50Nm
GB
50