Checks Before And After Use; Breaking In - Beta EVO 4T Owner's Manual

2

CHECKS BEFORE AND AFTER USE

For safe driving and long vehicle life you should:
• Check all fl uid levels.
• Check the correct operation of the brakes and brake pad wear (page 43).
• Check pressure, general condition and thickness of tread (page 10).
• Check that the spokes are properly tightened.
• Check the chain tension (page 54).
• Check the adjustment and the operation of all the cable controls.
• Inspect all the nuts and bolts.
• With the engine running, check the operation of the headlight, the rear and brake
lights, the indicators, the warning lights and the horn.
• Wash the motorcycle thoroughly after off-road use (page 58).

BREAKING IN

The breaking-in period lasts approximately 10 hours, during which it is advisable to:
• Avoid travelling at constant speed.
• For the fi rst 3 hours of use, the engine should only be used at up to 50% of its power.
The engine speed should not exceed 7000 rpm.
• For the next 7 hours of use, the engine should only be used at up to 75% of its
power.
WARNING:
After the fi rst 3 hours to replace the engine oil.
This procedure should be followed each time piston, piston rings, cylinder, crankshaft or
crankshaft bearings are replaced.
GB
24